Activity

I’ve fixed the broken link – thanks for bringing it to my attention. Just send me an email if you’ve ordered and want to get your password early 🙂

Matt,

The link you have “cannot be found” when I click it.

Cate’

Hi,
I’m waiting on my first diypackraft, a Telkwa. Looks like a very fun project.

Today I made an iron stand. Can’t wait to get started.

Cate’

Hi Barbara, this is the only failure I’m aware of, and it’s a good lesson for us all: https://www.diypackraft.com/forums/topic/packraft-failure-near-drowning/

The least stress will be near the tip of the stern, so you could try there. Wherever is convenient should be fine though.

Thanks Matt. I’m using a 210D nylon with TPU coating similar (if not the same) as the original fabric. I got the kit from someone here in the UK that didn’t get around to building but wanted to add the orange seam strips for a different look. I’ve got the original blue strips – wish I’d used them now!!

The test seams have all been very strong…[Read more]

Cool! Excellent work, and thanks for posting!

I don’t know what fabric you’re using, but assuming you’ve tested the welds and you’re satisfied they’re strong, then if you’re careful to avoid leaving any gap where the two pieces meet then it should work out fine. You can’t heat seal a fabric patch over Seam Grip though (or to the inside of the tube fabric, for that matter); instead, I would…[Read more]

Finally getting around to posting some shots of my first Telkwa build this summer! Matt’s instructions really are unbelievably good. It took me about 60 hours because I am nothing if not a little obsessive, but less quality guidance would have had me crying instead of wrapping this up with a finished boat that I couldn’t be more stoked on! The…[Read more]