Heat increase Coverite Black Baron? - DIY Packraft

Tagged: Coverite, temperature

This topic has 2 replies, 3 voices, and was last updated 6 years, 8 months ago by Matt (Admin).

Creator

Topic
April 22, 2018 at 7:22 pm #6121

rtullett
Participant

Tried a few test welds with a modified Coverite Black Baron. Worked pretty well but the iron could stand to be a tad hotter in my opinion. I had it on full blast. Is there a way to adjust the temperature control to go slightly hotter?

Thanks Rodney
Creator

Topic

Viewing 1 reply thread

Author

Replies
- April 25, 2018 at 1:11 pm #6158
  
  Matt (Admin)
  Keymaster
  
  Hi Rodney – Bruce wrote a post partially about that here: https://www.diypackraft.com/forums/topic/heat-sealing-tools/#post-4265
  
  Cheers
- April 23, 2018 at 7:34 am #6123
  
  Derek
  Participant
  
  I thought the same, but I found if you use masking tape to protect the TPU and use the entire flat surface of the iron, it goes pretty quick and makes a good seal. Then just use the tip for the finer details.
Author

Replies

Viewing 1 reply thread

You must be logged in to reply to this topic.