Kwok Wah Lai

Don’t tell anyone, but double coated 420D and 1000D fabrics will be added to the shop later this Spring 😉

Don’t tell anyone, but double coated 420D and 1000D fabrics will be added to the shop later this Spring 😉

Hi Jeremy, @akjw7

In general, a good place to start is in piece #5 (either Left or Right) near the seam with piece #4 and on the down-slope on the outside of the tube. If you’re measuring during construction, that’s about 38 cm (15″) up from the corner between pieces 4 and 5 on the outside of the tube, and about 7 cm (2.75″) away from the seam.…[Read more]

Hi Jeremy, @akjw7

In general, a good place to start is in piece #5 (either Left or Right) near the seam with piece #4 and on the down-slope on the outside of the tube. If you’re measuring during construction, that’s about 38 cm (15″) up from the corner between pieces 4 and 5 on the outside of the tube, and about 7 cm (2.75″) away from the seam.…[Read more]

testing to see if nesting is working….

In general, a good place to start is in piece #5 (either Left or Right) near the seam with piece #4 and on the down-slope on the outside of the tube. If you’re measuring during construction, that’s about 38 cm (15″) up from the corner between pieces 4 and 5 on the outside of the tube, and about 7 cm (2.75″) away from the seam.

I recommend using t…[Read more]

In general, a good place to start is in piece #5 (either Left or Right) near the seam with piece #4 and on the down-slope on the outside of the tube. If you’re measuring during construction, that’s about 38 cm (15″) up from the corner between pieces 4 and 5 on the outside of the tube, and about 7 cm (2.75″) away from the seam.

I recommend using…[Read more]

Check out Andy’s red DIY Packraft!

Beautiful work, @tyler!

That looks like a good solution, Hiroshi!

That looks like a good solution, Hiroshi!

Some people have been having issues with their Clover Mini Iron II not getting hot enough (especially the 240V version sold outside North America). If you’re in this situation you could try wrapping the heating element and/or shaft with aluminum foil to insulate it so more heat is conducted through the shaft to the foot. Most of the iron’s heat is…[Read more]

Some people have been having issues with their Clover Mini Iron II not getting hot enough (especially the 240V version sold outside North America). If you’re in this situation you could try wrapping the heating element and/or shaft with aluminum foil to insulate it so more heat is conducted through the shaft to the foot. Most of the iron’s heat is…[Read more]

Looks good! I think this is a good option for those with access to a sewing machine. Thanks for the tip!

Looks good! Thanks for the tip!

Excellent – sounds like an easy modification 🙂