- DIY Packraft

Uncle Fred replied 7 months, 3 weeks ago

That’s really cool. I need to come up with an adapter that functions the same way for my pump but also supports the top-up valve.
Dwayne replied 6 months, 4 weeks ago

I found this 3d printed adapter posted on Printables.com. It is a perfect fit for the boston valve and, with a slight internal diameter adjustment, will fit snugly over the top-up inflation stems for the backrest and seat.

https://www.printables.com/model/809119-inflation-bag-adapter-for-packraft-boston-valve
Derrick replied 5 months, 3 weeks ago

If I understand correctly, cutting the Boston valve isn’t necessary. You just need a flange on the inflation bag and put a valve piece between the inflation bag flange and the packraft flange. This should work because I think flanges can be screwed to both ends of the value (with the cap open obviously). You can use a valve with the rubber bit removed to quickly inflate the packraft then switch to a valve with the rubber bit still there to top up the with the inflation bag (no longer needing to top off with your lungs). Is this correct? Is that how you have been using it? I’m considering getting another Boston valve for my inflation bag to try it out. Does it work well?
- Matt (Admin) replied 5 months, 3 weeks ago
  
  Haha, I never thought of that, but you’re absolutely right – you could just iron the flange to the bag.
  
  You might be able to screw the inflation bag flange onto the boat’s check valve after it’s screwed in for the final top-up… yes, I do think that would work. The downside is that screwing the bag on and off would almost certainly take longer than using your mouth for those last five or six breaths. It’s possible you could get a higher air pressure in the packraft using the bag, but because the threads aren’t a perfect match between the flange and the top side of the check valve, I’d be careful to avoid damaging them by trying to force a lot of air in.
  
  I actually haven’t tried the valve-in-the-bag method myself, so if you test this before I get to it, please let us know how it works out!

José

@studio67